Need help?Do you have a question about the Honeywell Sensepoint XCD and is the answer not in the manual?
General| Type | Fixed Gas Detector |
|---|---|
| Ingress Protection | IP66/67 |
| Display | LCD |
| Output | 4-20 mA, Relay |
| Certification | ATEX, IECEx |
| Sensor Type | Electrochemical, Infrared |
| Humidity | 0 to 99% RH (non-condensing) |
| Material | Stainless Steel |
| Detection Principle | Depends on Sensor Type |
| Power Supply | 24 VDC nominal (17-32 VDC) |
Specific operating conditions for safe use with flammable sensors.
Specific operating conditions for safe use with oxygen sensors.
Guidance on selecting the optimal location and mounting for the detector.
Step-by-step instructions for installing the sensor cartridge.
Details on SOURCE and SINK wiring for the transmitter.
Explains the terminal connections for controller, relays, and sensor.
Information on power supply voltage, consumption, and cable length.
Explains effective earth/ground bonding for EMC and RFI immunity.
Detailed procedure for zeroing and span calibration of sensors.
Step-by-step guide for performing zero calibration.
Step-by-step guide for performing span calibration.
Specific considerations for zeroing and span calibration of H2S sensors.
Step-by-step guide for replacing the sensor cartridge.
Table detailing error messages, descriptions, and actions.
Explains how to access and use the configuration mode.
How to select the attached sensor and target gas type.
To Next Page
