Need help?Do you have a question about the Honeywell Searchline Excel Open-Path and is the answer not in the manual?
General| Type | Open-path gas detector |
|---|---|
| Detection Range | 0-5 LEL.m (Lower Explosive Limit meters) |
| Power Supply | 24V DC |
| Target Gas | Methane, and other hydrocarbons |
| Detection Principle | Infrared (IR) absorption |
| Path Length | Up to 120 meters |
| Operating Temperature | -40°C to +55°C |
| Humidity | 0% to 95% RH (non-condensing) |
| Output | 4-20 mA, Modbus |
| Ingress Protection | IP66 |
| Enclosure Rating | Stainless steel |
| Certifications | ATEX, IECEx, FM, CSA |
Key safety warnings and precautions for operating the gas detector.
Important cautions regarding the use and maintenance of the gas detector.
General considerations for locating and mounting the gas detector.
General precautions and recommendations for electrical installation compliance.
General power supply requirements and unit consumption details.
Steps for mechanical and electrical installation of the gas detector.
Procedures for accurate alignment and commissioning of the gas detector.
Setting up the system controller using the gas detector's output signal.
Guidance for personnel carrying out installation checks and tests.
Installation and operation procedures specific to the Cross-Duct Excel.
Step-by-step guide for installing the Cross-Duct Excel system.
Electrical installation precautions and recommendations for Cross-Duct Excel.
Commissioning process for the Cross-Duct Excel gas detector.
Using the gassing cell for calibration checks.
To Next Page