Honeywell Chronotherm III User Guide

CHECKING THE PROGRAM
TIMES AND TEMPERATURES
You can check all the stored
settings without affecting the
permanent program.
IPREAI
CHECKING THE CURRENT
TEMPERATURE SETTING
PRESENT
0
SETTING
Press a single key to compare
actual room temperature to the
setting at any time.
Press and hold until the desired
period shows on the display. The
start time and temperature set-
ting will appear on the display.
Press and release to display the
next day’s time and temperature
for that period.
Press and release to return to
normal operation.
[“:]
Press and release. The display
will show the current tempera-
ture setting for several seconds,
then revert to the room
temperature.
I”““1
During recovery from energy
savings, the setting displayed will
not match the programmed set-
ting. This is because the ther-
mostat gradually changes the
temperature setting during rec-
overy to provide maximum com-
fort combined with most efficient
use of the heating or cooling
equipment
25
26

Honeywell Chronotherm III Specifications

General

Operating Modes	Heat, Cool, Auto, Off
Programming	7-day programmable
Stages	1 Heat/1 Cool
Type	Programmable
Voltage	24VAC
Display	Digital
Programmable Periods	4 per day
Backup Battery	AA alkaline batteries (2)
Temperature Range	40°F to 90°F (Heating)