Honeywell Chronotherm III User Guide

You have completed the time l ’
and temperature program for
I!H
-a
another day. Now you can copy
it into additional days if you wish.
l -
H
0
H
,’
NOTE: The display will show
32” F until the thermostat is
mounted on the subbase and
the system is powered.
Press and release to enter the
copy mode. The next day flashes
on the display.
Press and release the Copy To
key to select the day that’s
flashing, or the Day key to
bypass it.
Continue, using the Copy To key
to bring up the next day, followed
by Copy To to select, or Day to
bypass the day, until all desired
days are selected.
Press and release to complete
the copy.
Repeat Step 4 as needed until all
days are programmed.
[-yx”“‘l
15
16

Honeywell Chronotherm III Specifications

General

Operating Modes	Heat, Cool, Auto, Off
Programming	7-day programmable
Stages	1 Heat/1 Cool
Type	Programmable
Voltage	24VAC
Display	Digital
Programmable Periods	4 per day
Backup Battery	AA alkaline batteries (2)
Temperature Range	40°F to 90°F (Heating)