Honeywell Chronotherm III User Guide

STEP 4
SET THE SCHEDULES AND
TEMPERATURES FOR THE
REMAINING DAYS
Use the procedures described in
Steps 2 and 3 and summarized
in this step to program the
remaining days.
Press and release to enter the
programming mode.
Press and hold until the day you
wish to program shows on the
display.
If COOL shows on the display,
press and release to switch to
HEAT.
Use the AHEAD/BACK keys to
set the time and the
WARMER/COOLER keys to set
the heating temperature.
13
Press and release the PERIOD
key to step through the remain-
ing time periods. Use the
AHEAD/BACK keys to set the _.
time and the WARMER/COOLER
keys to set the heating tempera-
ture for each time period.
Press and release so COOL
shows on the display.
Press and release the PERIOD
key to step through the time
periods, and use the WARMER/
COOLER keys to set the cooling
temperature for each period.
14

Honeywell Chronotherm III Specifications

General

Operating Modes	Heat, Cool, Auto, Off
Programming	7-day programmable
Stages	1 Heat/1 Cool
Type	Programmable
Voltage	24VAC
Display	Digital
Programmable Periods	4 per day
Backup Battery	AA alkaline batteries (2)
Temperature Range	40°F to 90°F (Heating)