System Installation Guide
8
69-2688—11 I/O-CHTSTAT03
Setup thermostat
3
Initial Power Up
1 Turn on AC power to the system.
2 Select Language. Press Next.
3 Select Application (Residential or
Commercial). Press Next.
The thermostat will iden tify the number
of units connected and then prompt
the installer to select the equipment
(Furnace or Air Handler, Heat Pump or
Air Conditioner) installed. Once config-
ured, the installer will be prompted to
add RedLINK accessories (page 9) and
setup the Installer Options (page 12).
4 Enter a Device Name. Press Next.
To Next Page
Loading...
