Chapter 8. PROGRAM SETUP
■ Setting pattern link items
(1) In the set value display state, move to the pattern link item to be set for the segment
on the programming map.
(A pattern link item is a program setting and is the same for each segment.)
(2) Press the ENTER key to make display panel 2 flash (registration of first setting).
(3) Use the ↑, ↓, ←, and → keys to make the first setting – setting the pattern link
value.
Setting range:0 to 99
0: no pattern link
1 to 99: program number at pattern link destination
(4) Press the ENTER key to stop the flashing on display panel 2.
(Pressing the FUNC and CLR keys causes display panel 2 to return to unset state
“
0
”and the flashing stops.)
●Display
•A pattern link item is a program setting and is the same for each segment.
• When setup data
C60
is set to 1, a pattern link item on the programming map is
skipped and not displayed.
NOTE A pattern link item setting does not use subfunctions.
To Next Page
Loading...
Need help?
General
