Chapter 2. NAMES AND FUNCTIONS OF PARTS
FUNC + PARA : Event configuration setting key
Press the PARA key while holding down the FUNC key in basic status display to
switch to the event configuration setting status.
FUNC + PID : Constant value control setting key
Press the PID key while holding down the FUNC key in basic status display to switch
to the event configuration setting status.
FUNC + PROG : Program setting (programming) key
Press the PROG key while holding down the FUNC key in the program run mode in
basic status display to go to the program setting (programming) status.
When the
PROG key is pressed while holding down the FUNC key in the program
setting status, allows you to change the number of the program to be set.
FUNC + CLR : Program delete key
Press the CLR key while holding down the FUNC key during registration in the pro-
gram setting status to delete a setting or return to a default value.
FUNC + ENTER : Segment insert/remove/RAMP/selection key
Press the ENTER key while holding down the FUNC key to go to the segment
insert/delete panel during SP and time setting in the program setting status.
Pressing the
ENTER key while the FUNC key is held down during SP registration in
the program setting status allows you to switch between RAMP-X and RAMP-T as well
as RAMP-X and RAMP-E.
↑
+ PROG : Program copy key
Press the PROG key while holding down the
↑
key in program run READY mode in
basic display status to go to the program copy panel.
FUNC + CLR + MESSAGE : General reset key
Press the CLR and MESSAGE keys simultaneously while holding down the FUNC
key
in the READY AUTO mode in the basic display status to go to the general reset
verification panel.
■ Loader jack
This jack allows the connection of a loader.
Do not insert plugs other than loader plugs.
The loader jack is not isolated from internal digital circuits.
When not in use, always replace the cap.
2-7
To Next Page
Loading...
Need help?
General
