Honeywell Dolphin CT60L1N - About CT60 Models for Use Hazardous Locations (CT60-L0 N-Xsxxx1 E, CT60-L1 N-Xsxxx1 E); Charge the Battery before Use

6 Dolphin CT60 Mobile Computer
About CT60 Models for use Hazardous Locations
(CT60-L0N-xSxxx1E, CT60-L1N-xSxxx1E)
Charge the Battery Before Use
Dolphin CT60 computers ship with the battery significantly discharged of power.
Fully charge the battery before using your computer for the first time.
You can charge the battery with a Dolphin CT50 series charging accessory before
or after you install the battery in the computer. A fully discharged battery charge in
approximately 6 hours.
To charge the battery before you install it in the computer:
• Insert the battery into the Honeywell Quad Battery Charger or the battery well of
a CT50 HomeBase or eHomeBase.
To charge the battery after installing it in the computer:
• Insert the computer into a CT50 HomeBase, eHomeBase, ChargeBase, NetBase,
USB Adapter, or Vehicle Power Adapter.
Note: Using the computer while charging the battery increases the time required to reach
a full charge.
Warning: Explosion Hazard-Batteries must only be changed or charged
in an area known to be non-hazardous. Use ONLY Honeywell
CT60 battery part number 318-055-013 or 318-055-016.
Avertissement: Risqued’explosion-Les batteries doivent uniquement
être remplacées ou rechargées dans un endroit non dangereux.
Utilisez UNIQUEMENT Honeywell CT60 batterie P/N 318-055-
013 or 318-055-016.
Warning: Battery must be locked when using the CT60 in a hazardous
environment.
Avertissement: La batterie doit être verrouillée lors de l'utilisation du
CT60 dans un environnement dangereux.
Warning: Additional spare batteries must not be carried in the hazardous
area.
Warning: The device must be protected from impacts with high impact
energy, permanent UV light emission and high electrostatic
discharge processes.