70 Dolphin CT60 Mobile Computer
Disable Wi-Fi Notifications and Set WLAN Radio Sleep Parameter
By default, when Wi-Fi is enabled, you receive notifications in the Status bar when
the computer discovers a wireless network. You can disable these notifications.
1. Swipe up from the bottom of the Home screen to access all apps.
2. Tap Settings > Network & Internet > Wi-Fi. Verify the Wi-Fi radio is turned
on.
3. Tap Wi-Fi preferences. The Configure Wi-Fi menu appears.
4. Tap the Open Network notification to toggle the setting on or off.
Connect to an Ethernet Network
To connect the computer to an Ethernet network, you need an eHomeBase or
NetBase.
1. Make sure the base is connected to your Ethernet network.
2. Place the computer in the base.
3. Swipe up from the bottom of the Home screen to access all apps.
4. Tap Settings > Network & Internet > Ethernet. The Ethernet setting is
turned On by default.
5. Tap Ethernet.
The Ethernet connection screen shows the current Ethernet connection. By
default, the computer assumes a DHCP connection, and that your network has
assigned an IP address automatically. If DHCP is working, the Ethernet base
should indicate that communication with the network is occurring.
6. (Optional) To assign a static IP address.
a. Tap DHCP and then select Static from the list.
b. Enter the required network information, and then tap Apply.
7. Tap Save.
How to Connect to Virtual Private Networks
The computer supports connecting to virtual private networks (VPNs). This section
describes how to add and connect to VPNs. To configure VPN access, you must
obtain details from your network administrator. You view and change VPN settings
in the Settings app.
Note: Before you can add or connect to a VPN network, you must enable a PIN or Password
screen lock method.
To Next Page
Loading...
