E
3
Point Network Gas Monitor User Manual 11
Using the Programming Menus
Using the Programming Menus
The programming menus provide a series of options that let you
customize your gas detection system. Press the enter key to access the
programming menus. If no buttons are pressed for 2 minutes, the unit
exits programming mode to normal operation.
Caution: Only qualied, knowledgeable personnel should use the
programming functions of this unit. Factory settings conform to specic
standards (see Specifications): any changes made to Alarm Levels may
aect manufacturer’s stated standards compliance.
Main Menu Options List
Each of the menu options listed provides access to further sub-menus.
Consult the following pages of this manual for menu use instructions.
Menu Option Description
Password Protects programming menus from unauthorized access.
Network
Defines device address, baud rate, BACnet ID, or
communication protocol.
Display Provides a choice of discrete display.
Relay
Defines whether the relays will be latched, failsafe, or
activated.
Buzzer Provides a choice between activated or silenced.
Alarm Allows configuration of various alarm levels.
Restore Restores the device’s factory configured calibration settings.
Temp Sets the maximum temperature level.
SetZero Sets the sensor zero.
SetSpan Calibrates the sensor span.
TestMode
Simulates events for testing purposes without affecting sensor
readings (used during installation).
Memory Reserved for authorized Honeywell Analytics technicians’ only.
Quit?
Exits the programming menus and returns the device to
normal operation mode.
To Next Page
Loading...
