Honeywell E3Point - Duct Mount Parts List

30 E
3
Point Network Gas Monitor User Manual
Specications
To change a sensor cartridge, disconnect all power to the device, pull
out the “smart sensor” cartridge, and press the replacement cartridge
into place. Be sure TOP/HAUT is toward the top of the unit. Once the
Smart Sensor is firmly in place, reconnect power. Use caution when
pressing the Smart Sensor cartridge into place to avoid bending the
pins.
Please see Using the Programming Menus in the Alarm Menu
section for special instructions for sensor changing gas types.
Duct Mount Parts List
Air intake tube
Air exhaust tube
Air flow
Ductmount housing
Housing cover
1
4
2
3
Figure 8. Parts of the Duct Mount
Item # Description
1 E
3
Point duct mount assembly cover
2 E
3
Point duct mount assembly base
3 Air intake and exhaust tubes
4 Plug (for air intake tube)