Honeywell E3Point - Standard Parts List

E
3
Point Network Gas Monitor User Manual 29
Specications
• To clear the asterisk from the display, press the ESC key for 8
seconds.
NOTE: If the system has experienced an over range condition, the sensor
should be bump tested to verify that it still responds to the presence of gas.
It should also be recalibrated at the next maintenance interval. See Periodic
Inspection and Maintenance.
Standard Parts List



 
Figure 7. Parts of the E
3
Point
Item # Description
1 E
3
Point cover
2 E
3
Point housing base
3 Main sensor assembly
4 Large rectangular J-box (not included)
5 Captive screw 10-32 x ½” (tamper proof screw also available)