Honeywell Enhanced Micro TDC 3000 User Manual

Enhanced Micro TDC 3000 User’s Manual 4-21 9/95
4.7.4
4.7.4 Prepare User-Written Programs
You can use Honeywell’s Control Language (CL) to write programs that accomplish user-
defined functions and algorithms. CL programs in the Application Module (CL/AM
programs) are bound to data points and execute as those points are processed in the AM.
CL is used to write sequence programs (CL/APM programs) that execute in Advanced
Process Managers.
If you do not want to write any CL programs at this time, skip to the next section.
4.7.4.1 CL Program Preparation
CL program preparation consists of
• Using the Text Editor to create and prepare a CL source file.
• Using the Command Processor to activate the CL compiler, which converts the
source file to a listing file and an executable object file.
• For CL/AM, using the Command Processor to activate the CL linker, which links and
loads the object file into the AM.
• For CL/APM, using the Advanced Process Module point’s detailed display to load
the object file into the APM.
Detailed instructions for these activities are in the following publications:
In the Implementation/AM - 3 binder: In the Implementation/APM- 2 binder:
• Control Language/AM Overview • Control Language/APM/Parameter
Reference Dictionary
• Control Language/AM Reference Manual • Control Language/APM Data Entry
• Control Language/AM Data Entry

Honeywell Enhanced Micro TDC 3000 Specifications

General

Brand	Honeywell
Model	Enhanced Micro TDC 3000
Category	Controller
Language	English