Honeywell Field Device Access Point - Page 48

FDAP CONFIGURATION
OWDOC-X256-en-323A
48
NOTE:
Location Options are only applicable to FDAP
Gen3 Anchor.
Altitude Reference: Altitude computed with
sea level as reference.
• Absolute → Altitude computed from
sea level.
• Relative → Altitude computed
relative to installation site.
NOTE:
Location Options are only applicable to FDAP
Gen3 Anchor.
ENU Coordinates
X Co-ordinate: East North Up or local
tangent plane X-axis co-ordinate.
Y Co-ordinate: East North Up or local
tangent plane Y-axis co-ordinate.
Z Co-ordinate: East North Up or local
tangent plane Z-axis co-ordinate.
Units of X, Y, and Z Co-ordinates must be
entered in cm.
NOTE:
Location Options are only applicable to FDAP
Gen3 Anchor.
GPS Parameters
GPS Latitude: World Geodetic System 84
(WGS84) latitude.
GPS Longitude: World Geodetic System 84
(WGS84) longitude.
Altitude: Altitude or height or elevation in
‘cm’ units of anchor from Earth’s sea level.
GPS latitude and longitude are representing
in deg with six digits after the decimal point.
READ COORDINATES: On clicking READ
COORDINATES, WDM will read the current
ENU Coordinates and GPS parameters
values from the Anchors.
Notes
Displays notes entered for the FDAP or
FDAP Gen3 and FDAP Gen3 Anchor.