3. Expand Vendor Parameters in the Property Panel.
4. In the Modbus Interface list, click the required option. The following are the interface
options available.
• Modbus RTU
• Modbus TCP
5. Configure one of the following depending on the Modbus interface option that you
have selected.
• If you have selected Modbus TCP Interface, configure the following under
Modbus TCP Settings.
▪ FEWIO IP Addr: IP address that needs to be assigned to FEWIO and the IP
address Subnet should be same as the IP address of slaves
▪ Subnet Mask: Subnet Mask
To Next Page
Loading...
