Honeywell Genesis 7580G - Page 173

11 - 19
Planet, Intelligent Mail Bar Code, and
Postnet with B and B’ Fields On
POSTAL26 6-46
Postal-4i, Intelligent Mail Bar Code, and
Postnet with B and B’ Fields On
POSTAL27 6-46
Planet, Postal-4i, Intelligent Mail Bar Code,
and Postnet On
POSTAL28 6-47
Planet, Postal-4i, Intelligent Mail Bar Code,
and Postnet with B and B’ Fields On
POSTAL29 6-46
Planet Code Check Digit Transmit PLNCKX1 6-47
*Don’t Transmit PLNCKX0 6-47
Postnet Check Digit Transmit NETCKX1 6-47
*Don’t Transmit NETCKX0 6-47
Australian Post Interpretation Bar Output AUSINT0 6-48
Numeric N Table AUSINT1 6-48
Alphanumeric C Table AUSINT2 6-48
Combination N and C Tables AUSINT3 6-48
Postal Codes - Linear
China Post (Hong Kong 2 of 5) Default All China Post (Hong Kong 2 of 5)
Settings
CPCDFT 6-48
*Off CPCENA0 6-48
On CPCENA1 6-48
China Post (Hong Kong 2 of 5) Msg.
Length
Minimum (2 - 80) *4 CPCMIN## 6-48
Maximum (2 - 80) *80 CPCMAX## 6-49
Korea Post Default All Korea Post Settings KPCDFT 6-49
*Off KPCENA0 6-49
On KPCENA1 6-49
Korea Post Msg. Length Minimum (2 - 80) *4 KPCMIN## 6-49
Maximum (2 - 80) *48 KPCMAX## 6-49
Korea Post Check Digit Transmit Check Digit KPCCHK1 6-49
*Don’t Transmit Check Digit KPCCHK0 6-49
EAS Settings
EAS Controller *Off EASTYP0 7-2
On EASTYP1 7-2
EAS Mode of Operation *Interlocked EASMOD0 7-2
Continuous on Enable EASMOD1 7-2
EAS Interlocked Duration Timeout EASTIM (0-5000) *100ms EASTIM##### 7-3
Imaging Default Commands
Image Snap Default all Imaging Commands IMGDFT 8-1
Imaging Style - Decoding SNPSTY0 8-1
*Imaging Style - Photo SNPSTY1 8-1
Imaging Style - Manual SNPSTY2 8-1
Beeper On SNPBEP1 8-1
*Beeper Off SNPBEP0 8-1
Selection
Setting
* Indicates default
Serial Command
# Indicates a numeric entry
Page