Programming Master Programming Level
PAS
The PAS (Positive Alarm Sequence) option will program the zone to delay panel activation (including alarm relay and communicator)
for a period of 15 seconds plus a programmable time of up to 3 minutes. To enable the PAS feature, press 3 while viewing the PAS/Pre-
Signal Screen. This option is available only for circuits programmed as smoke detector circuits. Refer to “Positive Alarm Sequence” on
page 90.
52 GF505 & GF510 Manual — P/N 53164:B5 6/12/2018
To Next Page
Loading...
