Performance Series IP Camera Software Configuration Guide
34
Parameter Function
Maximum 32 characters.
Ethernet Card
Select an Ethernet port. The default is Wire (Default).
Note If you modify these settings, you should reboot your
camera to activate the new setup.
Mode
Select Static or DHCP mode.
The IP Address, Subnet mask, and Default Gateway fields are
unavailable when you select DHCP mode to automatically
search for the IP address.
If Static mode is selected, you must manually assign the IP
Address, Subnet mask, and Default Gateway.
If DHCP mode is selected, the IP Address, Subnet mask, and
Default Gateway are assigned automatically.
Note IP Address, Subnet mask, Default Gateway, and DHCP
are read-only when PPPoE is enabled.
MAC Address Displays the MAC address.
IP Version Select the IP version you are using: IPv4 or IPv6.
IP Address
If Static mode is selected, type values for the IP Address, Subnet
mask, and Default Gateway.
Preferred DNS
Server
Enter the preferred DNS server IP address.
Alternate DNS
Server
Enter an alternate DNS server IP address.
Enable ARP/Ping
If you know the camera’s MAC address, then use the ARP/Ping
command to modify or set the camera’s IP address.
Before operating the camera, please ensure that the network
camera and the PC are in the same LAN.
Perform the following steps to set the IP address:
1.
Get an IP address. Set up the network camera and the PC in
the same LAN.
2.
Get the physical address from the label on the network
camera.
3.
Open the Run interface (Start menu > Run), and then type the
following commands:
arp -s <IP Address> <MAC> ping -l
480 -t <IP Address>
For example:
arp -s 192.168.0.125 11-40-8c-18-10-11 ping -l
480 -t 192.168.0.125
4.
Reboot the camera. If the setup was successful, output
information such as Reply from 192.168.0.125... will appear
in the command output lines.
5.
Close the command line.
Open your browser, type http://<IP address> in the address
To Next Page
Loading...
Need help?
General
