Honeywell H4W2PER2 - Configuring Network Event Settings; Figure 7-12 SD Card Error Warning Configuration Interface; Figure 7-13 Capacity Warning; Table 7-4 SD Card Configurations

Configuring Video Analytics
57
Figure 7-12 SD Card Error Warning Configuration Interface
Figure 7-13 Capacity Warning
Table 7-4 SD Card Configurations
Parameter Function
Event
Type
Select an event type in the dropdown list.
Enable Check to enable the selected event type
Send
Email
When enabled, the system sends an email alert when the event occurs.
Capacity
Limit
Enter a value between 0-99. If the capacity of SD card exceeds the set value,
it will send a warning.
Note
Emails cannot be sent if the network is offline or if there is an IP
conflict.
Configuring Network Event Settings
Go to Setup Video Analytics Event Network.