Honeywell H4W2PRV2 User Manual

Performance Series IP Camera Software Configuration Guide
48
Date and Time
Figure 5-32 Date and Time Configuration Interface
Table 5-22 Date and Time Configurations
Parameter
Function
Date Format Select a date format from the drop-down list.
Time Format Select a time format, either 24-hour or 12-hour.
Time Zone Select the time zone for the camera.
Current Time Set it to set the system’s time. Click Save to activate this time.
Sync PC Click to sync the camera’s time with your PC’s time.
DST Set when Daylight Saving Time begins and ends. Select Date or Week.
NTP Click to enable synchronization with a Network Time Protocol (NTP) server.
NTP Server Configure the NTP server.
Port Configure the port for the NTP server.
Update Period Configure synchronization periods between the camera and the NTP server.
Account Setup
The system supports up to 15 characters for the user name or user group name. You can use letters,
numbers, and the underscore character ( _ ) for the user or group name.
You can configure up to 18 users and eight groups (default factory settings). The factory default setup
includes two user levels: user and admin (case-sensitive).
When configuring groups, you can configure the rights of those groups. You can also set rights for
individuals within groups.
Note
User management adopts group/user modes. The user name and the group
name should be unique. A user can be included in only one group at a time.

Honeywell H4W2PRV2 Specifications

General

Brand	Honeywell
Model	H4W2PRV2
Category	IP Camera
Language	English