20 | Performance Series Fixed Minidome Camera Configuration Guide
www.honeywellvideo.com
The Camera Title can be up to 15 alphanumeric characters in length.
Figure 18 Setting the CAMERA TITLE
4. Move the cursor to select an alphanumeric character.
Choose a character from the displayed range of A~Z, and 0-9 using the Up, Down,
Left and Right OSD controls.
5. Enter the selected character into the camera title by pressing SET.
The cursor in the camera title moves to the next position after each character is
input, by pressing SET.
6. Repeat the above steps until the camera title is complete.
Note If an incorrect character has been input into the camera title, you have
two options for correcting the camera title:
• Move the cursor to select CLR and press SET to delete the entire
camera title. Enter another camera title, as needed.
• Move the cursor to select either or and press SET to change the
position of the cursor in the current camera title. Continue to press
SET on either or until the cursor is highlighting a character in
the camera title that you want to change. The selected character will
be replaced by the next character that you input (as described
above). Continue to move the cursor and input new characters, as
needed, until the camera title is corrected.
7. Select RETURN by using the Up/Down/Left/Right OSD controls to return to
SPECIAL menu.
CAMERA TITLE
ABCDEFGHIJKLMNOP
QRSTUVWXYZ012345
6789 !"#$%&’()*+
,-./<=>?@[\]^_
CLR POS RET
CAMERA001______
To Next Page
Loading...
