Safety Instructions | 7
800-12003V1 - A - 01/2013
Safety Instructions
BEFORE OPERATING OR INSTALLING THE UNIT, READ AND FOLLOW
ALL INSTRUCTIONS. AFTER INSTALLATION, retain the safety and
operating instructions for future reference.
1. HEED WARNINGS - Adhere to all warnings on the unit and in the operating
instructions.
2. INSTALLATION
• Install in accordance with the manufacturer’s instructions.
• Installation and servicing should be performed only by qualified and
experienced technicians to conform to all local codes and to maintain your
warranty.
• Do not install the unit in an extremely hot or humid location, or in a place
subject to dust or mechanical vibration. The unit is not designed to be
waterproof. Exposure to rain or water may damage the unit.
• Any wall or ceiling mounting of the product should follow the manufacturer’s
instructions and use a mounting kit approved or recommended by the
manufacturer.
3. POWER SOURCES - This product should be operated only from the type of power
source indicated on the marking label. If you are not sure of the type of power
supplied to your facility, consult your product dealer or local power company.
WARNING This device is configured for 12 VDC operation only, do NOT
connect to higher voltage. Use only with NRTL approved 12 VDC power supplies. To
prevent potential ground loop issues, a separate PSU should be used for each
camera. A multiple output PSU may be used if the multiple output PSU has isolated
and protected (2A MAX) outputs.
4. HEAT - Situate away from items that produce heat or are heat sources such as
radiators, heat registers, stoves, or other products (including amplifiers).
5. WATER/MOISTURE - The HD41X camera is rated for indoor operation. Do not use
this unit near water or in an unprotected outdoor installation, or any area classified
as a wet location.
6. MOUNTING SYSTEM - Use only with a mounting system recommended by the
manufacturer, or sold with the product.
7. ATTACHMENTS - Do not use attachments not recommended by the product
manufacturer as they may result in the risk of fire, electric shock, or injury to
persons.
To Next Page
Loading...
