Honeywell HD41 - Sync (Internal Synchronization); Resolution; Reset

26 | Performance Series Fixed Minidome Camera Configuration Guide
www.honeywellvideo.com
MOVE-XY You can change the position of the current Privacy Mask with the MOVE-XY
option (see Figure 26).
a. Use the Up or Down OSD controls to select MOVE-XY and press SET.
b. Use the Up, Down, Left or Right OSD controls to move the Privacy Mask in
the direction that you have pressed.
c. Press SET to confirm the new position of the Privacy Mask.
AREA DISPLAY ON : Activates area display. OFF: Disables the area display.
4. Repeat these steps for each Privacy Mask needed for your camera.
5. Move the arrow indicator to RETURN after completing the setup to return to
SPECIAL menu.
Sync (Internal Synchronization)
This feature is not applicable for the HD41X camera (SYNC fixed at internal)
When the SPECIAL menu is displayed, use the Up or Down OSD controls to access the
SYNC menu (see Figure 27).
Figure 27 SPECIAL Menu - SYNC Submenu Selection
Resolution
This feature is used to enhance RESOLUTION. Side effects to this feature may include
increased noise and storage consumption.
Reset
Use this option to RESET the camera to its factory default settings.

SPECIAL
CAMERA TITLE OFF
ADJUST 
MIRROR OFF
MOTION DET OFF
PRIVACY OFF
SYNC INT
RESOLUTION NORMAL
RESET NO
RETURN 

L.L.
ADJUST  100
RETURN 