Honeywell HERMetic UTImeter Gtex Chem - Selecting the Temperature Resolution

30 www.tanksystem.com
9.4 Selecting the temperature resolution
The temperature reading can be given with 1 or 2 digits after the dot. Select the appropriate resolution as shown on Figure 9-4.
• Switch on the equipment,
• Wait until the temperature is displayed,
• Press on “+” to enter the settings menu,
• Press on “enter”, “LED menu” is displayed,
• Press on “+”; “T. unit” is displayed,
• Press on “+”, “Resol.” is displayed,
• Press on “enter”,
• Select the resolution by pressing on “+” one or more times,
the pointer shows the resolution selected,
• Press “-” two times to come back in measurement mode.
ON
UTImeter
Battery
Init.
*********
25.94°C
Settings
T. unit
Resol. >0.0°
> 0.00°
Ver x.xx
LED menu
░ ░ ░ ░ ░
97%
E
E
-
-
-
+
+
+
+
+
+
-
Figure 9-4
The new setting is stored in the permanent memory.