Honeywell HRHT4082 - Page 110

www.honeywell.com/security
110 | Performance Series HQA Digital Video Recorder Remote User Guide
Figure 5-1 Alarm Configuration Interface
You can use the web page un-install tool uninstall_web.bat to uninstall the web control plugin.
Note Before uninstalling the Web control, close all web pages. If you do not, then you
might experience an error.
Table 5-1 Alarm Configurations
Configuration Type Configuration Description
Alarm Type
Motion Detection Click to enable Motion Detection. The
system will then trigger an alarm when motion
is detected under the specified
circumstances.
Tampering Click to enable Tampering. The system
triggers an alarm when video tampering
occurs.
HDD Error Click to enable the Disk Error alarm. The
system triggers an alarm when a disk error
occurs.
Video Loss Click to enable Video Loss. The system then
an alarm when video loss occurs.
HDD Full Click to enable the Disk Full alarm. The
system triggers an alarm when the disk is full.
Intelligent
Detection
Face detection, for example.
Operation Message Click to enable Message. Then the system
automatically pops up an alarm icon on the
Alarm button on the Main interface when
there is an alarm.
Alarm Sound
Alarm Sound Click to enable the Alarm Sound. Then the
system triggers an alarm sound when an
alarm occurs. You can choose the sound.
Sound Path Select the sound file.