Honeywell HRHT4082 - Configuring for Abnormalities

www.honeywell.com/security
78 | Performance Series HQA Digital Video Recorder Remote User Guide
4. Click Save to save your settings.
Configuring for Abnormalities
Click Abnormality in the Event configuration interface to open the Abnormality configuration
interface.
PTZ Activation When PTZ activation is configured, the system can activate
PTZ operation when an alarm is detected.
1. Click Setup to open the PTZ Activation configuration
interface.
2. Select a preset, tour, or pattern from the drop-down menu.
3. Click Save.
Snapshot Click to enable the Snapshot function. Channel snapshots
are taken according to the schedule you configure. Alarm
snapshots are taken when an alarm occurs.
Voice Prompts
Select to enable audio broadcast/voice prompts in response to
the event you selected in the drop-down list of event types.
File Name Select a file for the voice prompt.
Show Message Click to enable a pop-up message on your local host PC
screen to let you know an alarm has occurred.
Send Email The system can send an email when an alarm is detected.
When you have enabled the Snapshot function, the system
can also send an image attached to the email. Go to Main
Menu
SettingNetworkEmail to configure the email
settings. See Configuring Email on page 53.
Buzzer Click to enable the Buzzer function. When an alarm occurs,
the buzzer beeps.
Message Enable to send a message to the device which supported the
3G/4G module when the event triggers.
Log Click to enable the DVR to record a local alarm log.
Table 3-16 Face Detection Configurations
Configuration Description