Honeywell HRHT4082 - Configuring the Camera Name; Configuring the Channel Type

www.honeywell.com/security
40 | Performance Series HQA Digital Video Recorder Remote User Guide
Figure 3-5 Save Path Configuration Interface
The default save path is C:\PictureDownload for snapshots and C:\RecordDownload for
recorded video.
Click Browse to change the save path, and then click Save.
Configuring the Camera Name
By default, the cameras are named "CAM 1", "CAM 2," "CAM 3," and so on. You can assign each
camera a descriptive name specific to your application (for example, "Front Entrance").
Figure 3-6 Camera Name Configuration Interface
Enter a new camera name, then click Save.
Configuring the Channel Type
By default, the channel type is set to Coax. You can change the channel type to UTP if
unshielded twisted pair (UTP) cabling is used, or to IP if you want to connect to an IP camera.