Configuration | 87
800-22740 - A - 02-2017
Configuring Holiday Settings
1. Click the Holiday Settings tab in the General settings configuration interface to open the
Holiday Settings configuration interface.
Figure 3-50 Holiday Settings Configuration Interface
2. Click Add Holidays, and the Add Holidays window appears.
Figure 3-51 Add Holidays Window
3. Enter a Holiday Name.
4. Select Enable or Disable from the drop-down menu.
5. Click to select a Repeat Mode, either Once or Always.
6. Click to select a Holiday Range, either Date or Week.
7. Enter a Begin Time and End Time.
8. Click Save to save the settings.
NTP Server Enter the NTP time server address.
Port Enter the NTP time server port.
Upgrade
Period/Interval
Configure the synchronization period between the DVR and
the NTP time server.
Table 3-22 Date & Time Configurations
Configuration Description
To Next Page
Loading...
