www.honeywell.com/security
56 | Performance Series HQA Digital Video Recorder Remote User Guide
Configuring UPnP
UPnP allows you to establish the mapping relationship between the LAN and the public network.
Here you can also add, modify, or remove a UPnP item.
Preparing for UPnP
1. In the Windows OS, click Start Control Panel Add or remove programs.
2. Click Add/Remove Windows Components, and then select Network Services from the
Windows Component Wizard.
3. Click Details, then check Internet Gateway Device Discovery and Control client and
UPnP User Interface. Then click OK to begin the installation.
4. Enable UPnP from the internet. If your UPnP is enabled in the Windows OS, then the DVR
can automatically detect it through the My Network Places.
5. Click UPnP in the Network configuration interface to open the UPnP configuration
interface.
Configuring UPnP
Figure 3-22 UPnP Configuration Interface
Configuring SNMP
SNMP allows the communication between the network management work station software and
the proxy of the managed device. It is reserved for a third party developer.
Table 3-12 UPnP Configurations
Setting Description
PAT Click to enable/disable UPnP.
UPNP VAV Report Enable/disable UPnP to work with iView Now.
LAN IP Enter the DVR’s IP address from the TCP/IP page.
WAN IP Enter the router IP address.
To Next Page
Loading...
