www.honeywell.com/security
88 | Performance Series HQA Digital Video Recorder Remote User Guide
Configuring Display Settings
Configuring Display/GUI Settings
Click Display in the General settings configuration interface to open the GUI settings
configuration interface.
Figure 3-52 Display Configuration Interface
Configuring Tours
In the Tour interface, you can set the Tour Interval, Split mode, Motion Detection Tour, and
Alarm Tour modes.
Click Tour in the Display settings configuration interface to open the Tour settings configuration
interface.
Table 3-23 GUI Configurations
Configuration Description
Resolution Select from four options: 1920x1080, 1280x1024 (default),
1280x720, and 1024x768.
Note You need to reboot the DVR to activate changes to the
resolution.
Transparency Configure the transparency of the GUI display. Select from
128 to 255.
Original Rate When enabled, the video displays in the aspect ratio of the
camera.
Time Display/Channel
Display
Click to enable these functions, which display the time and
channel on the video monitor.
Preview Enhancement Check to enable Preview Enhancement, to optimize the
preview video.
Video Spot Enable to display live video on a secondary "spot" monitor.
To Next Page
Loading...
