LYNX Touch Installation and Setup Guide
- 53 -
Programming the Control
Register through AlarmNet Direct Website
If the communications module has been programmed through AlarmNet Direct, the data must be
transferred to the module, and the module must be registered by visiting:
https://services.alarmnet.com/AlarmNetDirect/userlogin.aspx.
Log in and follow the on-screen prompts.
If required, click on “Dealer Signup” from the login screen to gain access to the Honeywell web-based
programming.
Dealer Sign-Up Direct Link: https://services.alarmnet.com/AlarmNetDirectP_Sign-Up.
Complete the sign-up form then follow the instructions. Only one sign-up per dealer is required. Once an
initial user is established, additional logins may be created by that user.
Please have the following information available when programming the device:
1. Primary City ID (two-digit number)
2. Primary Central Station ID (two-digit hexadecimal number)
3. Primary Subscriber ID (four-digit number)
4. MAC ID and MAC CRC number (located on outside of box and on label inside module. Once the module
is registered, log out of the AlarmNet Direct website.
Register by Phone
To register the module by telephone, call the AlarmNet Technical Assistance Center (TAC) at 1-800-222-
6525.
Please have the following information available:
• MAC number (found on the label).
• Subscriber information (provided by the Central Station), including a city code, CSID, and a subscriber ID.
• When instructed to do so, select Register Device in the LYNX Touch Diagnostics to complete the
registration.
Register through LYNX Touch Diagnostics
Register the module using the LYNX Touch Diagnostics and the following procedure.
SCREEN ACTION
Comm. Diagnostics
1. Select “Comm. Diagnostics” The System displays the following options depending upon
the communication device that is installed:
WiFi Location
None
Configure
WiFi
Information
GSM
Information
Use the down arrow to scroll to the next page of options. Use the arrow to return to
the previous page:
Communication
Status
Test
Communication
Setup
Communication
Communication
ID Numbers
Setup
Communication
2. Select “Setup Communication”. The System advances to the Registration screen and
the following options are displayed:
Register
Device
Register Device
With PIN
Update
Server
Factory
Defaults
3. Select “Register Device”.
The registration message is sent and the unit waits
for the acknowledgement. (Refer to the table below for applicable
registration messages.)
Note: Register Device can be cancelled by selecting “Cancel”. The registration process is
aborted and the message Registration Cancelled! is displayed.
To Next Page
Loading...
Need help?
General
