LYNX Touch Installation and Setup Guide
- 67 -
System Operation
Central Station Messages
The following messages are sent by the communications modules (4GL/4GLC or 3GL/3GLC, ILP5 and L5100-WiFi) for
the conditions listed below.
Power On / Reset E339 C0803
Primary Communication Path Supervision E350 C0951 R350 C0951
Secondary Communication Path Supervision E350 C0952 R350 C0952
Test 5555 5555 9
The Control Panel sends its own general code (E353) for a trouble condition. The Control panel sends tamper trouble
(E341), tamper alarm (E145), power loss (E301) and low battery (E302) messages.
To Next Page
Loading...
