EasyManuals Logo

Honeywell L5210 Series User Manual

Honeywell L5210 Series
88 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #34 background imageLoading...
Page #34 background image
LYNX Touch Installation and Setup Guide
- 34 -
Programming the Control
Program the Z-Wave Module
The following system options are programmed in this section:
Option Function
Z-Wave Enables or disables the Z-Wave Module
Temperature Display Toggles between Fahrenheit and Celsius (for Z-Wave compatible Thermostats)
Note: If applicable, preprogrammed defaults for the L5210/L7000 Control are shown on the screen unless otherwise noted.
SCREEN ACTION
5100-100-067-V0
Z - Wave
1. Enter Program Mode and default the panel (Refer to “Loading Factory Defaults”).
2. Select “Z-Wave”
The System displays the following options:
Z-Wave
Temperature Display
Z-Wave
Enabled-Installed Telephone
3. Select “Z-Wave”. The system toggles between the following options:
Enabled – Installed Telephone Side
Disabled
Select “Enabled – Installed Telephone Side”.
Temperature Display
Fahrenheit
4. If you wish to change the temperature format, select “Temperature Display”. The
system toggles between the following options:
Fahrenheit
Celsius
5. Select “Save”.
6. Select the “” key to return to the previous screen or the Home button to return to
the Home screen.
7. Include Z-Wave devices. (Refer to Including/Excluding Z-Wave Devices in the Home
Automation Guide P/N 800-19979 or higher.)

Table of Contents

Other manuals for Honeywell L5210 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honeywell L5210 Series and is the answer not in the manual?

Honeywell L5210 Series Specifications

General IconGeneral
BrandHoneywell
ModelL5210 Series
CategorySecurity System
LanguageEnglish

Related product manuals