❁ ➼ ❪ ❁
SECURING THE PREMISES
SECURING THE PREMISESSECURING THE PREMISES
SECURING THE PREMISES
System Status
Before arming your system, all protected doors, windows, and other protection zones must be
closed or bypassed (see the BYPASSING PROTECTION section).
READY LED: The green READY indicator on the control will be lit if the system is ready to
be armed. If blinking, the system is not ready.
ß Þ à á ë
❀
❖
✽ ◗
❖ ❆
P ● ✽ ● ●
❖ ❄
❊
❈ ■ ❈
❘
❆
P ❍
❁
✽
❏
● P
❆
✽ ✾ P
❆ ■
P ❘ ❋ ✽ ❲ P
❈
▲ P
❆
✽ P
❈ ❈ ❄ ❅ ❈
❍ ✽ ▲
❄ ❈
❋ ❉
■
◆ P ◗ ◗
❆ ❄
◗
❆ ■
P
❏
✽
■ ❈ ❏ ❖
✽
❍
❅ ❆ ❆
✽
❈ ❏
●
❏
P
❏
✽
❄
◆
❏ ❖
✽ ● ❉ ●
❏
✽ ❑ ✿
Depending on the current state of the system the following phrases may be heard:
fire alarm [zone voice descriptors]
carbon monoxide alarm [zone voice descriptors]
alarm [zone voice descriptors]
fire fault [zone voice descriptors]
carbon monoxide fault [zone voice descriptors]
fault [zone voice descriptors]
low battery [zone voice descriptor]
system low battery
check system
AC loss
zones bypassed
chime
VOLUME LEVEL: The volume level of system announcements can be increased or decreased. Refer to
the MESSAGE RECORDING/PLAYBACK section for the procedure.
The READY LED will be lit steadily once all protection zones have been closed or bypassed.
You may now arm the system.
To Next Page
Loading...
Need help?
General
