Honeywell LYNX Touch User Manual

– 72 –
IN THE EVENT OF TELEPHONE OPERATIONAL PROBLEMS
In the event of telephone operational problems, disconnect the control by removing the plug from the
RJ31X (CA38A in Canada) telephone wall jack. We recommend that your certified installer
demonstrate disconnecting the phones on installation of the system. Do not disconnect the phone
connection inside the control/communicator. Doing so will result in the loss of your phone lines. If the
regular phone works correctly after the control/communicator has been disconnected from the phone
lines, the control/communicator has a problem and should be returned for repair. If upon disconnection
of the control/communicator, there is still a problem on the line, notify the telephone company that they
have a problem and request prompt repair service. The user may not under any circumstances (in or
out of warranty) attempt any service or repairs to the system. It must be returned to the factory or an
authorized service agency for all repairs.

Honeywell LYNX Touch Specifications

General

Zones	Up to 64 wireless zones
Voice Control	No
Remote Control	Yes, via mobile app
Keypad Zones	No
Partitions	No
Voice Prompts	Yes
Built-in Z-Wave	Yes
Display	Color touchscreen
Communication	Cellular
Wireless Zones	64
Automation	Z-Wave
Siren Output	Built-in
Wireless Frequency	345 MHz
Supported Security Devices	Door/window sensors, motion detectors
Compatibility	Honeywell 5800 series wireless devices