EasyManuals Logo

Honeywell LYNX Touch User Manual

Honeywell LYNX Touch
80 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #71 background imageLoading...
Page #71 background image
71
Regulatory Agency Statements
q
r
s
s t
r
s s
This equipment complies with Part 68 of the FCC rules. On the front cover of this equipment is a label that contains the FCC
registration number and Ringer Equivalence Number (REN). You must provide this information to the telephone company when
requested.
This equipment uses the following USOC jack: RJ31X
This equipment may not be used on telephone-company-provided coin service. Connection to party lines is subject to state tariffs.
This equipment is hearing-aid compatible.
s
: The Industry Canada Label identifies certified equipment. This certification means that the equipment meets
telecommunications network protective, operational and safety requirements as prescribed in the appropriate Terminal Equipment
Technical Requirements document(s). The Department does not guarantee the equipment will operate to the user
s satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local
telecommunications company. The equipment must also be installed using an acceptable method of connection. The customer
should be aware that compliance with the above conditions may not prevent degradation of service in some situations.
Repairs to certified equipment should be coordinated by a representative designated by the supplier. Any repairs or alterations
made by the user to this equipment, or equipment malfunctions, may give the telecommunications company to request the user to
disconnect the equipment.
Users should ensure for their own protection that the electrical ground connections of the power utility, telephone lines and internal
metallic water pipe system, if present, are connected together, This precaution may be particularly important in rural areas.
: Users should not attempt to make such connections themselves but should contact appropriate electric inspection
authority, or electrician, as appropriate.
l
tiquette d
Industrie Canada identifie le mat
riel homologu
. Cette
tiquette certifie que le mat
riel est conforme aux
normes de protection, d
exploitation et de s
curit
des r
seaux de t
l
communications, comme le prescrivent les documents
concernant les exigences techniques relatives au mat
riel terminal. Le Minist
re n
assure toutefois pas que le mat
riel
fonctionnera
la satisfaction de l
utilisateur.
Avant d
installer ce mat
riel, l
utilisateur doit s
assurer qu
il est permis de le raccorder aux installations de l
enterprise locale de
t
l
communication. Le mat
riel doit
galement
tre install
en suivant une m
thode accept
e da raccordement. L
abonn
ne doit
pas oublier qu
il est possible que la conformit
aux conditions
nonc
es ci-dessus n
emp
che pas la d
gradation du service dans
certaines situations.
Les r
parations de mat
riel nomologu
doivent
tre coordonn
es par un repr
sentant d
sign
par le fournisseur. L
entreprise de
t
l
communications peut demander
l
utilisateur da d
brancher un appareil
la suite de r
parations ou de modifications
effectu
es par l
utilisateur ou
cause de mauvais fonctionnement.
Pour sa propre protection, l
utilisateur doit s
assurer que tous les fils de mise
la terre de la source d
energie
lectrique, de lignes
t
l
phoniques et des canalisations d
eau m
talliques, s
il y en a, sont raccord
s ensemble. Cette pr
caution est particuli
rement
importante dans les r
gions rurales.
L
utilisateur ne doit pas tenter de faire ces raccordements lui-m
me; il doit avoir racours
un service
d
inspection des installations
lectriques, ou
un
lectricien, selon le cas.
The
(REN) assigned to each terminal device provides an indication of the maximum number of
terminals allowed to be connected to a telephone interface. The termination on an interface may consist of any combination of
devices subject only to the requirement that the sum of the Ringer Equivalence Numbers of all the devices does not exceed 5.
(IES) assign
chaque dispositif terminal indique le nombre maximal de
terminaux qui peuvent
tre raccord
s
une interface. La terminaison d
une interface t
l
phonique peut consister en une
combinaison de quelques dispositifs,
la seule condition que la somme d
indices d
quivalence de la sonnerie de tous les
dispositifs n
exc
de pas 5.
r
WARNING: The LYNX Touch must be installed to provide a separation distance of at least 7.8 in (20 cm) from
all persons and not co-located or operated in conjunction with any other transmitter
.

Other manuals for Honeywell LYNX Touch

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honeywell LYNX Touch and is the answer not in the manual?

Honeywell LYNX Touch Specifications

General IconGeneral
ZonesUp to 64 wireless zones
Voice ControlNo
Remote ControlYes, via mobile app
Keypad ZonesNo
PartitionsNo
Voice PromptsYes
Built-in Z-WaveYes
DisplayColor touchscreen
CommunicationCellular
Wireless Zones64
AutomationZ-Wave
Siren OutputBuilt-in
Wireless Frequency345 MHz
Supported Security DevicesDoor/window sensors, motion detectors
CompatibilityHoneywell 5800 series wireless devices

Related product manuals