– 58 –
USER FUNCTIONS
USER FUNCTIONSUSER FUNCTIONS
USER FUNCTIONS
Remote Phone Control Feature
❹ ❷ ❺ ❻ ❼ ❷ ❤ ❽ ❻ ♠ ❷ ♦ ❻ ♠ ❼ ❸ ❻ ✐ ♦ ❻ ❺ ❺ ❥ ♠ ❾ ⑩
Enter User Code (within eight seconds). Upon entering remote phone control mode the Lynx will
announce
❢
System, enter code
❣
.
To remotely disarm system:...........................................................User Code + [1]
To remotely arm in AWAY mode: ..................................................User Code + [2]
To remotely arm in STAY mode: ...................................................User Code + [3]
To remotely arm in AWAY or STAY mode with no delay:..............User Code + [2] or [3] + [0]
To remotely Bypass zones: ...........................................................User Code + [6] + zone no.
To remotely activate Forced Bypass: ............................................User Code + [6] + [#]
To remotely check system status:..................................................[
✻
]
To end remote phone session: Hang Up or .................................User Code + [9]
❿ ➀ ➁ ➂ ➃
: (1) Check with your installer to see if the Forced Bypass mode has been enabled.
(2) When bypassing zones, make sure a confirmation beep sounds for each zone that has been
bypassed.
To Next Page
Loading...
Need help?
General
