8
MPA1C1 Access Control Unit
You can use the MPA1C1 panel as a standalone panel with inde-
pendent card and transaction storage or, with a host software
upgrade, as a fully monitored online access control device.
The three panel inputs are capable of four state supervision:
Normal, Alarm, Short and Cut. One input is used for door status
on each door. There is one tamper input in the MPA1C1.
All three inputs can also be used as additional inputs when not
required for their default purpose. By default non-supervised
inputs are used for Request to Exit (REX) button, Door Position
Switch (DrCnt), and Tamper (T-LID).
Note: The MPA1C1 can only connect to OSDP readers.
For MPA1C1 reader specifications, see Hardware Specifications
beginning on page 39.
To Next Page
Loading...
Need help?
General
