Programming
88 MS-5UD/MS-10UD Series PN 52626:B 8/01/2008
3.5.5.4.3 Central Station
Central Station programming configures the control panel DACT for contacting the central
station. Pressing 3 while viewing Onboard DACT Screen 1 will cause the following screens to
be displayed:
3.5.5.4.3.1 Reporting
To enable the DACT for reporting FACP activity to the central station, press 1 while viewing
Central Station Screen #1 so the display reads Reporting Yes. Each press of the 1 key will
toggle the display between Reporting Yes and Reporting No.
3.5.5.4.3.2 Report Style
The DACT can be programmed to transmit reports to primary and/or secondary central station
phone numbers as a backup. Press 2 while viewing Central Station Screen #1 to display the
following screen:
Press 1 to have all reports transmitted to the central station secondary phone number as a
backup only if the primary phone line fails, 2 to transmit all reports to both the primary and
secondary phone numbers all of the time or 3 to send reports to the first available phone
number.
ON BOARD DACT
1=PRIM PHONE
2=SCND PHONE
3=CENTRAL STATION
Onboard DACT
CENTRAL STATION
1=REPORTING NO
2=REPORT STYLE
FIRST AVAILABLE
Central Station Screen #1
CENTRAL STATION
1=PRIMARY
2=SECONDARY
3=CALL LIMIT 0
Central Station Screen #2
REPORT STYLE
1=BACKUP ONLY
2=BOTH
3=FIRST AVAILABLE
Backup Reporting Screen
To Next Page
Loading...
