28 N3680 Decoded Engine User Guide
Scanner-Bioptic Packet Mode
Packet Mode On must be scanned to set the scan engine’s format so it is compati-
ble with a bioptic scanner. Default = Packet Mode Off.
Scanner-Bioptic ACK/NAK Mode
Bioptic ACK/Nak On must be scanned so the scan engine will wait for an ACK or
NAK from a bioptic scanner after each packet is sent. The Scanner-Bioptic ACK/
NAK Timeout (below) controls how long the scanner will wait for a response.
Default = Bioptic ACK/NAK Off.
Scanner-Bioptic ACK/NAK Timeout
This allows you to set the length (in milliseconds) for a timeout for a bioptic scan-
ner’s ACK/NAK response. Scan the bar code below, then set the timeout (from 1-
30,000 milliseconds) by scanning digits from the inside back cover, then scanning
Save. Default = 5100.
To Next Page
Loading...
