N3680 Decoded Engine User Guide 21
Control Character Output
This selection sends a text string instead of a control character. For example, when
the control character for a carriage return is expected, the output would display
[CR] instead of the ASCII code of 0D. Refer to ASCII Conversion Chart (Code Page
1252) on page 174. Only codes 00 through 1F are converted (the first column of
the chart).
Note: Control + X (Control + ASCII) Mode overrides this mode.
Default = Off.
Keyboard Modifiers
This modifies special keyboard features, such as CTRL+ ASCII codes and Turbo
Mode.
Control + X (Control + ASCII) Mode On: The scan engine sends key combinations
for ASCII control characters for values 00-1F. Windows is the preferred mode. All
keyboard country codes are supported. DOS mode is a legacy mode, and it does
not support all keyboard country codes. New users should use the Windows mode.
Refer to ASCII Conversion Chart (Code Page 1252), page 174 for CTRL+ X Values.
Windows Mode Prefix/Suffix Off: The scan engine sends key combinations for
ASCII control characters for values 00-1F, but it does not translate any prefix or
suffix information.
Convert All Characters
to Upper Case
Convert All Characters
to Lower Case
Control Character Output On
* Control Character Output Off
To Next Page
Loading...
