ID2000 Series Installation & Commissioning Manual
Contents
ii997-433-000-5, Issue 5
May 2010
Contents
1 Introduction 1
1.1 CE Marking 1
1.2 System Design and Planning 1
1.3 Personnel 1
1.4 General 1
1.4 Date-dependent Functions 2
Installation: Sections 2-7
2 Installation Guide 3
2.1 How to Use this Guide 3
2.1.1 Related Documents 3
2.1.2 Warnings and Cautions 3
2.1.3 Tips 3
2.1.4 Glossary of Icons 4
2.2 Pre-Installation Check List 5
2.2.1 Some DO’s and DONT’s 5
2.3 Transient Protection 6
2.4 Installation 7
2.4.1 Checking Your Panel for Damage 7
2.4.2 What to do if Your Module is Damaged 8
2.4.3 Back Box Fixing 9
2.4.4 Electronics Modules 10
2.5 Replacing the Electronics Modules 11
2.6 Flush Mounting Bezel (Optional) 11
2.7 Mounded Front Covers 13
3 Cabling 14
3.1 Cabling Instructions 14
3.1.1 Cable Terminations 15
3.2 Cable Installation Notes 16
3.2.1 Introduction 16
3.2.2 Quality of Cable and of Cable Installation 16
3.3 EMC Considerations 17
3.3.1 Screen Termination 17
3.3.2 Ferrite Sleeves (Optional) 17
3.4 MICC Cables 17
4 Sensors and Modules 18
The following markings are used either
on the panel hardware or in the
documentation. They have the following
meaning:
WARNING: Risk of electric
shock. Before working on
mains connections, ensure
mains power supply to the
panel is disconnected.
CAUTION: Refer to the
accompanying documentation.
(When used in the
documentation, this marking is
normally associated with
additional instructions).
To Next Page
Loading...
Need help?
General
