122 NFW-100X Manual — P/N LS10131-001NF-E:C 7/25/2018
Central Station Communications - POTS Transmission Transmittal Priorities
Red LEDs are provided on the circuit board to identify which telephone line is activated. Also, a green LED labeled Kissoff will turn on
whenever the control panel has successfully transmitted reports to the Central Station. The Kissoff LED may turn on several times during
communications with a Central Station.
The table below shows UL listed receivers which are compatible with the NFW-100X.
1. With 685-8 Line Card with Rev. 4.4d software
2. With 124060V206B and 124063 Line Card Rev. B
3. With version V2.4 Receiver and 126047 Line Card Rev. G
4. With 124077V2.00 Receiver and 126047 Line Card Rev. M
5. With V.7301 Receiver S/W
6. With 01.01.03 Receiver S/W and Line Card 01.01.03
7. With software V1.86
8. With software V1.72
9. With DSP4016 and V1.6 Line Card
10. With software V3.9
IMPORTANT! It is the installer’s responsibility to ensure that the Digital Alarm Communicator/Transmitter is compatible with the
Central Station Receiver, utilized by the monitoring service, prior to installation. The Compatibility Table provides a list of compatible
receivers and associated software versions for the receivers. Changes in the hardware and/or software by the receiver manufacturers may
affect the receiver compatibility with the FACP DACT. After completing the installation, communication between the DACT and Cen-
tral Station Receiver must be tested and verified.
Format
Ademco
685 (1)
Ademco
MX8000 (2)
Silent Knight
9500 (3)
Silent Knight
9800 (4)
Osborne Hoffman
2000E (5)
Radionics
6600 (6)
SurGard
MLR2 (7)
SurGard
System III (8)
SurGard
MLR-2000 (9)
FBI
CP220FB (10)
Honeywell Security
AlarmNet 7810-ir
0SIA-DCS-8
1SIA-DCS-20
2 Ademco Contact ID
Table 5.1 Compatible UL Listed Receivers
To Next Page
Loading...
