50 NFW-100X Manual — P/N LS10131-001NF-E:C 7/25/2018
Programming User Programming
3.2 User Programming
The NFW-100X is completely field programmable and requires no special software skills. While programming the NFW-100X, the fire
protection capabilities of the control panel are
enabled.
Site-specific programming may be accomplished in any of the following ways:
• Autoprogramming Feature - This is a convenient method for quickly bringing the FACP addressable SLC devices on-line without
the necessity of programming each device individually. Refer to “Autoprogram” on page 52 for a detailed description of
Autoprogramming.
• Manual programming or editing, using the FACP keypad or a PC keyboard
• Remote Programming and Editing Feature - allows creation and editing of site-specific custom programs using a Windows-based
computer and Ethernet connection. For programs requiring a large amount of data entry, this method may be preferred. The FS-
Tools programming utility can be downloaded from www.notifier.com for this purpose.
• Local Programming and Editing Feature - allows creation and editing of site-specific custom programs using a Windows-based
computer and the FACP USB connection. For programs requiring a large amount of data entry, this method may be preferred. The
FS-Tools programming utility can be downloaded from www.notifier.com for this purpose.
•The System Normal screen will be displayed in a programmed system with no active alarms, troubles or supervisories, as illustrated
below:
Read Status mode can be entered while the panel is in any
mode of operation. If an alarm or supervisory event exists at the panel, the
event must be cleared before entering Programming mode. To access any of the programming or read status features, the Enter or Mode
key must be pressed, which will cause the LCD to display the following:
Pressing 1, while this screen is being displayed, will cause the control panel to enter the Read Status Mode which allows the user to view
the programmed features and status of the control panel The Read Status feature is not password protected. Refer to “Read Status” on
page 114 for a detailed description of this feature.
Pressing 2 will select user Programming Mode which may only be accomplished by an authorized person. After pressing 2, a screen will
prompt for a password. After entering the correct password, the user may select from a list of programming options.
RECALL Insert
**
##
@@
A - Z A - Z
0 - 9 0 - 9
■
(on YZ key) Space bar
——
//
••
ENTER Enter
F1 F1
F2 F2
F3 F3
F4 F4
ACK/STEP F5
SILENCE F6
DRILL F7
RESET F8
SYSTEM NORMAL
10:00A 010118
1=READ STATUS MODE
2=PROGRAMMING MODE
3=FSTOOL UP/DOWNLOAD
4=USB UP/DOWNLOAD
To Next Page
Loading...
