Performance Series Indoor Day/Night H.264 IP Camera User Guide
Document 800-09312V2 Rev A 31
08/2012
After the IP Utility software is installed, you can change the Administrator or Guest
passwords.
Step 1: Confirm Your System Requirements
Note Windows administrator privileges are required to install the Honeywell IP
Utility and associated software.
Note Contact the network administrator if there are any questions regarding the
local area network (LAN) or any other network related issues.
Install the Honeywell IP Utility on a workstation with the minimum requirements (outlined in
Table 3-2). After the IP Utility is installed, the same computer workstation can be used to
access the web client.
Table 3-1 User Profiles for Honeywell IP Utility and the Web Client
Interface Administrator Guest
Honeywell IP
Utility
• View the list of available network devices
and connect to the devices.
• Configure the IP network settings.
• Upgrade firmware.
• Change the password to access the IP
Utility application.
• Change the access passwords to the
web-client application.
• View the list of devices available on the
network.
• View system settings including device
name, IP address, and MAC address.
Web Client • View video and network settings.
• Configure compression settings.
• Configure camera setup.
• Configure video analytics.
• Guest users are limited to the Live View
tab where they can view video.
To Next Page
Loading...
Need help?
General