Need help?Do you have a question about the Honeywell Performance Series and is the answer not in the manual?
General| IR Range | Up to 30m (98ft) |
|---|---|
| Weatherproof Rating | IP66 |
| Power Supply | PoE (Power over Ethernet) IEEE 802.3af, 12 VDC |
| Image Sensor | 1/2.8" CMOS |
| Vandal Resistance | IK10 |
| Video Compression | H.265/H.264/MJPEG |
| Storage | MicroSD card slot (up to 256GB) |
| Network Connectivity | 10/100 Mbps Ethernet |
Details how to adjust camera image properties like brightness, contrast, and hue.
Covers configuration of video encoding settings for primary and secondary streams.
Details how to configure the NVR's IP address, subnet mask, and gateway.
Covers the configuration of network ports for various NVR functions.
Covers the setup of email notifications for alarm events.
Covers setting up motion detection regions, periods, and event actions.
Instructions for configuring video loss detection and associated actions.
Explains how to set up camera tampering detection and event actions.
Covers configuration of scene change detection and associated event actions.
Instructions for configuring external alarm inputs and their event actions.
Guides on setting up external alarm configurations for IP cameras.
Covers configuration of face detection parameters and event actions.
Details how to configure audio detection sensitivity and event actions.
Covers basic storage settings like HDD full mode and pack duration.
Instructions for setting up recording schedules for different event types.
Details how to manage HDD status, type, and format settings.
Covers the configuration of FTP connections for remote image uploads.
Provides advanced settings for HDD management, including stream assignments.
Details how to configure recording types (Auto, Manual, Stop) for channels.
Explains how to perform manual HDD detection and view detection reports.
Covers general system settings like device name, language, and auto logout.
Instructions for setting system time, date, time zone, and Daylight Saving Time.
Details how to configure display settings, including resolution and overlays.
Covers managing user accounts, groups, and their privileges.
Guides on configuring security settings like IP filtering and trusted/blocked sites.
Instructions on how to restore camera, network, event, storage, and system defaults.
Covers PC requirements and steps for logging into the web client.
Details methods for adding cameras, including searching and manual configuration.
Instructions for setting up email notifications for events.
Covers configuration of various event detections like motion, video loss, and tampering.
Provides an overview of storage configuration sections.
Covers general system settings like date, time, display, and accounts.
Checks for power input, cable connections, and outlet issues.
Troubleshoots power stability, environment, and HDD cable connections.
Focuses on checking HDD cable connections and inspecting for damage.
Covers monitor input selection, power cycling, and video cable checks.
Addresses issues with camera image settings and privacy mask configurations.
Checks if recording is enabled and general recording settings.
Checks date/time settings and advises on replacing the main board battery.
Verifies PTZ camera connection, protocol, and NVR configuration.
Addresses sensitivity, schedule, and zone setup for motion detection.
Checks for IP address or MAC address conflicts.
Ensures alarm settings and cable connections are correct.
Checks alarm settings, cable connections, and loop connections.
To Next Page
