Honeywell Performance Series User Manual

Performance Series Network Video Recorder User Guide
150
Figure 12-8 Web Service Login Window
6. Enter your username and password, then click Login.
A message pops up asking if you want to install controls.
Figure 12-9 Controls Installation Popup Message
7. Click the message and the following message is displayed:
Figure 12-10 Run Plugin Message
8. Click Run to run the plugin. The relevant plug-ins might be blocked by your web browser
security settings as shown in the following figure:
Figure 12-11 Unblocking Security Plug-ins
9. Click Allow.
Main Window
The main window is divided into 4 main sections. You can select different channels and
different modes at the bottom of the interface.

Honeywell Performance Series Specifications

General

IR Range	Up to 30m (98ft)
Weatherproof Rating	IP66
Power Supply	PoE (Power over Ethernet) IEEE 802.3af, 12 VDC
Image Sensor	1/2.8" CMOS
Vandal Resistance	IK10
Video Compression	H.265/H.264/MJPEG
Storage	MicroSD card slot (up to 256GB)
Network Connectivity	10/100 Mbps Ethernet