Honeywell Performance Series User Manual

Performance Series Network Video Recorder User Guide
74
3. Enable the auto register function in the NVR.
The NVR should now be able to automatically register to the proxy server.
Configuring Alarm Center Settings
1. Go to Main Menu  Setting  NETWORK  Alarm Center, the following window is
displayed:
Figure 7-13 Network Alarm Center Settings Window
2. On the Alarm Center page, select the Enable check box to enable the alarm center
function.
3. Configure the following settings:
Protocol Type: Select Private.
Host IP: Enter the host address of your alarm platform.
Port: Enter the port of your alarm platform.
4. Set the Self-report Time (everyday or a specific day of the week at a specific time, or
never).
5. Click Apply to save your settings.
6. If you want to save your settings and exit the SETTING menu, click OK.

Honeywell Performance Series Specifications

General

IR Range	Up to 30m (98ft)
Weatherproof Rating	IP66
Power Supply	PoE (Power over Ethernet) IEEE 802.3af, 12 VDC
Image Sensor	1/2.8" CMOS
Vandal Resistance	IK10
Video Compression	H.265/H.264/MJPEG
Storage	MicroSD card slot (up to 256GB)
Network Connectivity	10/100 Mbps Ethernet