Honeywell Performance Series User Manual

Configuring Event Settings
79
Note
You also need to set the alarm recording period. Go to Storage

Schedule to configure the current channel for scheduled
alarm recording. See Configuring the Video Recording Schedule
on page 39.
PTZ Activation: Select the check box to activate PTZ functions, and then click Set. In the
PTZ Activation window, for each PTZ camera, select the preset, tour, or pattern that you
want to be called when the people counting event occurs, and then click OK.
Tour: Select the check box to enable a tour of the selected channels.
Snapshot: Select the check box to take a snapshot of selected channels.
Log: Select the check box to enable logging of the people counting event.
Voice Prompts: Select the check box to enable the playing of a voice prompt audio file
when a people counting event is triggered. Use the File Name drop-down arrow to select
the audio file to play for the events.
Buzzer: Select the check box to activate a buzzer noise at the NVR.
8. Click Apply to save your settings. To return to the main menu, click OK.
• Configuring Alarm Outputs on page 98.
• Configuring POS Settings on page 101.
Configuring Motion Detection Settings
To set up motion detection regions
1. Go to Main Menu  SETTING  EVENT  VIDEO DETECTION  Motion Detection.

Honeywell Performance Series Specifications

General

IR Range	Up to 30m (98ft)
Weatherproof Rating	IP66
Power Supply	PoE (Power over Ethernet) IEEE 802.3af, 12 VDC
Image Sensor	1/2.8" CMOS
Vandal Resistance	IK10
Video Compression	H.265/H.264/MJPEG
Storage	MicroSD card slot (up to 256GB)
Network Connectivity	10/100 Mbps Ethernet